License Plate Frames

An online information booklet about License plate frames!

What are 'Casting' made license plate frames? What are 'Coined' license plate frames?

Home
Decal Position
Plain frames
Notched Frames
Factory Font Views
Script Frame Views
3D frames
SUV & Truck Frames
Tight-fit frames
Wide-Bottom frames
Wide-Side Frame
Company Info Page
Installation tips



 
pad

License Plate Frame

4-hole frame – 2-holes in the vehicle

When installing a 4-hole frame on vehicles with only 2 holes, use the extra screws and nuts to secure the frame in the two unused holes and install the screw covers.  When doing this (rather than using a 2-hole thin frame), there won’t be two empty holes showing in the license plate.
 

Installing TOP engraved frames

Our top engraved frame kits come with a special stainless steel adapter plate that allows mounting the plate and frame assembly from the bottom, even if the holes on the vehicle are at the top.  There is nothing to drill or modify in any way.  This is a simple installation and all the necessary screws are included.  It's very neat and unique.
  1. Snap the 2 nylon nuts into the slots of the adapter plate
  2. Attach the adapter plate to the vehicle at the top holes with the original screws
  3. Mount the plate and frame from the bottom holes in the nylon nuts with the screws and cap retainers that were included.
  4. Snap the caps over the retainers.
 
Installation tip - Hardware and screw covers

Hardware caps: When installing the screws--don't over-tighten them. You are only installing a license plate and frame. It doesn't take a lot of torque to hold it on the vehicle (unlike a wheel). Over-tightening of the screws distorts the retainers and makes it very difficult to snap the screw covers in place. Screw covers must "snap" onto the retainers or they will fall off. When properly installed the screw covers act as a theft deterrent.

 


Ford Sport Track vehicles
Sport Trac information

When ordering engraved license plate frames for Sport Trac vehicles, order the Truck Frame (top engraved) kit for the rear and the regular bottom engraved frame for the front.

The special adapter plate included in the Truck frame kit allows the frame to be mounted with the screws at the bottom. Nothing to drill or modify--it's all the the unique design. It's a really neat installation.

Hit Counter


• Home • Decal Position • Plain frames • Notched Frames • Factory Font Views • Script Frame Views • 3D frames • SUV & Truck Frames • Tight-fit frames • Wide-Bottom frames • Wide-Side Frame • Company Info Page • Installation tips •

PQAA, Inc.
d/b/a Premium Quality Auto Accessories
1871 S Patrick Drive
Indian Harbour Beach, FL 32937
321-779-9654

Copyright ©  2006 PQAA, Inc. All rights reserved